Note:

This product is finished assembled,you do not need to assemble it by yourself
Due to the difference between the measurement, the dimension and weight may have little error.

Specification: ( Manual)

Brand:NikolaToy
Product Name:NIKOLATOY brushless motor super turbofan engine model decoration
Material:PLA
Craft:High precision 3D printing technology
Product Size:25cmX12cmX10cm
Product Weight:480g
Package Size:860g
Package Weight:29cmX16cmX17cm

Using Notes:

1. When removing and putting the engine back from the base, please make sure that the power is off.

2. Before turning the forward and reverse raotation switch, please push the throttle push rod back , to ensure that it is switched when not rotating or at low speed status, to reduce the impact damage to the brushless motor coupling.

3. The engine is in car mode at low speed and in crossing mode at high speed.

The system will switch modes when the throttle push at a certain point and the engine may shake, which is a normal phenomenon.

4. It can work for a long time in half throttle state and supports charging while rotating.  

Do NOT charge in full throttle state to avoid excessive heating and possible damage to the engine when it is unattended for a long time.

5. When fully charged, it can run for about 30 minutes at full throttle in forward rotation.  

 It is best to run for less than 15 minutes at full throttle in reverse rotation (the wind blown out by forward rotation can dissipate the heat of the brushless motor, and the heat dissipation effect is not good in reverse rotation).

6. The engine vibrates greatly at high speed. Please place it on a rough horizontal surface to prevent possible vibration from causing displacement and falling.

7. When charging, the green light flashes to indicate charging is in progress, and stays on to indicate full charge

 (when the battery is out of power, it will trickle charge for a few minutes, during which time the green light will stay on).

Package included:
1x Turbofan Engine Model （with battery）